How To Fix An Over Wound Watch

The more you take the time to wind the more wear you are putting your clock through.

How to fix an over wound watch. It looks a little like a wagon wheel with spokes. DIY watch repairs is an area of much debate. The watch is fully wound but it doesnt run.

If the watch doesn t start again the owner believes it has been wound so tight that it somehow jammed the spring or winding mechanism. Use a knife or thin screwdriver and carefully pry open the cover to see where the problem is within the watch. Antique watch repair Sales and restoration for over 39 years.

Rolex recommends gentle cleaning a cloth to help your prize Submariner keep its lustre and soap water and a. Its impossible to wind it any further so it must be over-wound. If the watch is a modern automatic then its something more serious.

If you wind until there is resistance to turning then you are finished. You cant over wind a Speedmaster unless you use pliers when the crown stops and this would probably break the stem anyway. To wind a watch manually turning the crown in the clockwise direction winds the spring turning it.

The staff is easily replaceable and the spring can be reattached to either the winder or the staff. You cant actually stop a watch by over winding it although if you keep trying to turn the crown when the watch is fully wound this can cause the balance to swing too far and might cause damage. The two most common problems are the spring not being properly connected and the staff being broken.

You proberbly have the skill to fix the watch. The steps that you must follow when troubleshooting your watch are. You have to check the watch spring condition to know how much winding you should give it.