Why Does My Ryobi Strimmer Keep Cutting Out

The most common problem with Ryobi trimmers is that the engine becomes progressively more difficult to start.

Why does my ryobi strimmer keep cutting out. The motor is the powerhouse of the mower which is responsible for rotating the blades. Mine does the same I kept charging my batteries but batteries are good cause I use them on my drills saws radio and they all work just fine so I know its not batteries mine only works for about 2-3 min and stops I take the battery off and right away put it back in and seems to work for a little bit a few seconds if I let go of the trigger before it stops it seems to work a little longer but. The best way to find out is to take the spark plug out of the engine and check its condition.

I screw the head back on ok after I put the cap up first but it keeps happening. When I clutch the upper control handle as one must do to start the strimmer then pull up on the lower control handle trigger the strimmer operates normally sometimes but other times it runs for 2-3 seconds then stops. It may just need adjusting but if it doesnt work with a re-adjustment if you can do it yourself you should disassemble carburetor.

If you can get your brush cutter going but it keeps cutting out and stalling you might be wondering why this is occurring. The typical trimmer cam have old fuel lines that leak causing engine to lose the fuel and die. Everything running perfectly but now after I fed the lines in as described for replacement I push the trigger the head spins and then falls off into 2 pieces.

The typical trimmer cam have old fuel lines that leak causing engine to lose the fuel and die. You may have to keep the throttle open a bit. There are three possible scenarios that are causing this problem.

The cutting string inside your Ryobi trimmer wraps around a spool which connects to a spring. Next hold the throttle wide open and slowly turn in the high speed until it really starts to smooth out and rev high and starts screaming then back this out until it starts to run rough or slows down. The main reasons why your trimmer line keeps breaking are.

Control Cable Parts Deflector Chute Parts Duct Venting Parts Engine Parts Fastener Parts Filter Parts. However it has developed a problem. Line is not designed for your trimmer.