How To Take The Back Off A Whirlpool Washing Machine

Unplug the Whirlpool washer and turn off the water lines.

How to take the back off a whirlpool washing machine. 1remove the top 4 screws at rear of washer top see the tech sheet for details you can remove all connection except the hose of water lever. Raise the washers lid and if applicable remove the agitator cap you can often use a flat-head screwdriver to pry the cap off or detach the fabric softener dispenser from the agitator. Locate the screws on either side of the washer console.

Open the lid and remove any additional installation materials stored in the washer drum. Up to 20 cash back So to get inside this washer you actually dont remove the back panel. Once youre able to d.

Pull the entire gear-case and agitator shaft out. 3grab the balance ring so the washer cabinet should be off ground use a hammer to hit the shaft the basket will be removed. There will be one clip on each side.

Agitators are longer and have obvious spindles. Open the lid on the washing machine and place your hand between the drum and the top of. Its located in the bottom center and is likely covered with a plastic cap.

Remove the three bolts that hold the gear-case on. So I need to decide whether to buy a new machine and remove the feet or arrange for the workbench to be lifted not an easy job due to the sink and the tiles. How to Remove Whirlpool Washer Back.

Step 3 Find the screws on the ends of the instrument panel and unfasten them with a screwdriver setting the screws aside in a safe place. Locate the screws on either side of the washer console. Remove the flat wavy silver metal clips that connect the top of the washer cabinet to the rear.